How to install eNSP

How to install eNSP?

eNSP is required to three plug-ins to assist, so first under the three plug-ins, and finally under the eNSP

Let's start with the Wireshark installation

It's very simple, basically just go straight to the next step

Go straight to the next step here

Note here that these are either installed in the default path, or you can create a new folder on the disk where you want to install them, and download them all into one folder

Go straight to the next step here

Note that Install is unchecked! Otherwise it will conflict with WinPcap.

Here too, don't check the box!!!!

Go straight to the next step here

Go straight to the next step here

Then just install it.

Then take a look at the WinPcap installation

Just go straight to the next step for each of these

Then look at the VM installation

This one too is just one step down.

It's red here, but it doesn't matter. Just agree.

I didn't get a chance to take a screenshot of the problems reported during installation, but remember to agree to

Finally, you can start installing eNSP!

First choose the language you know best

Then just go straight to the next step here

Here you have to choose to accept the agreement, and then click Next

Here you have to select the same folder on the disk where you installed it previously

This will have a shortcut on the desktop when it's checked.

Here's why you need to install those plug-ins before installing eNSP Without them, you can't install eNSP, and they're auxiliary plug-ins for eNSP.

Then click Next to start the installation

Note here that after these installations are complete, only these two programs are displayed on the desktop